Operation CHARM: Car repair manuals for everyone.
Hosted by mcallihan.com

Theft Deterrent - Additional Keys - Programming

IMPORTANT: The first key used in this procedure must not be a valet key (gray in color). A valet key will not allow you to learn additional keys.

Additional keys (up to 10) may be programmed using the following procedure if a valid (learned) key is available for that vehicle.

The "term" learn or learned refers to copying the driver's key and system information to additional keys. To learn another ignition key, it is necessary to first create a duplicate of the mechanical cut of the current key. The ignition key being learned must be read by the theft module in the following sequence. A drivers key must be used to learn any additional keys.

This procedure is for learning additional keys only, not for replacing a key due to loss of all currently programmed keys.
1. Insert the valid drivers key (black in color) and start the vehicle.
2. Once the vehicle has started, turn the ignition switch to the OFF position and remove the key.
3. If the vehicle does not start refer to Programming Replacement Keys, Ign Cy4 or PCM.
4. Insert the key to be learned and rotate the key to the ON position within 10 seconds of removing the previously used key.
5. The SECURITY indicator will turn off once the key has been learned. It may not be apparent that the SECURITY indicator went on due to how quick it learns the new key.
6. Repeat these steps to program additional keys.