Steering Column Control Module - Programming

Tilt/Telescoping Soft Stops
After replacement of the steering column tilt/telescoping module, it is necessary to program the tilt/telescoping soft stops. Each soft stop is a programmable end of travel that is set approximately 0.5 inch (1.3 cm) from the mechanical end of travel. The steering column has a soft stop set at each end of the tilt up/down movement and at each end of the telescoping in/out movement. The system uses soft stops to prevent wear on the system by ensuring that the steering column movement stops before it reaches its mechanical end of travel in any direction. The soft stops are initially programmed at the factory. The stop positions may be reprogrammed, which is necessary any time the steering column tilt/telescoping module is replaced, as described in the following procedure.