Antenna Control Module: Service and Repair

REMOVAL PROCEDURE
1. Remove the headliner.
2. Disconnect the electrical connectors from the radio antenna module.
3. Remove the fastener retaining the radio antenna module to the roof beam.
4. Remove the radio antenna module.

INSTALLATION PROCEDURE
1. Install the radio antenna module to the roof beam, ensuring that the alignment tab is properly located.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install radio module retaining fastener.

Tighten
Torque the fastener to 9 N.m (80 lb in).

3. Connect the electrical connectors to the radio antenna module.
4. Install the headliner.