Seat Horizontal and Vertical Drive Cable Replacement

Seat Horizontal and Vertical Drive Cable Replacement

Removal Procedure
Caution: Refer to SIR Handling Caution in Cautions and Notices.

1. Remove the front bucket seat. Refer to Front Seat Replacement - Bucket (Front Seat Replacement - Bucket) .
2. Remove the front seat cushion . Refer to Front Seat Cushion Replacement (Front Seat Cushion Replacement) .
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.




4. Squeeze the collar of the cable in order to release the cable.




5. Pull the cable out of the fitting until the cable end clears the fitting.
6. Remove the cable or cable/sensor assembly.



Installation Procedure





1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the clip snaps into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the front seat cushion. Refer to Front Seat Cushion Replacement (Front Seat Cushion Replacement) .
4. Install the front bucket seat. Refer to Front Seat Replacement - Bucket (Front Seat Replacement - Bucket) .