Radio Replacement (With RPO Code UY4)

REMOVAL PROCEDURE
1. Remove the rear shelf trim panel.
2. Remove the fasteners (4) retaining the radio (5) to the radio/navigation processor bracket.
3. Disconnect the electrical connectors (1,3) and the antenna (2) from the radio (5).
4. Remove the radio (5) from the radio/navigation processor bracket.

INSTALLATION PROCEDURE
1. Install the radio (5) to the radio/navigation processor bracket.
2. Reconnect the antenna (2) and the electrical connectors (1,3) to the radio (5).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the fasteners (4) that retain the radio (5) to the radio/navigation processor bracket.

Tighten
Torque the radio fasteners to 5 N.m (44 lb in).

4. Install the rear shelf trim panel.

For a description of the RPO Code(s) shown in this article/image refer to the RPO Code List found at Vehicle/Application ID Application and ID