U1192

Refer to one of the following Data Link Connector (DLC) Schematics:
^ Data Link Connector Power and Ground (LH Drive)
^ Data Link Connector Power and Ground (RH Drive)

DTC U1001 - U1254 Loss of XXX Communications:

Diagnostic Chart (Part 1 Of 2):

Diagnostic Chart (Part 2 Of 2):

CIRCUIT DESCRIPTION
During normal vehicle operation modules connected to the class 2 serial data circuit monitor the class 2 serial data circuit for serial data communications. Operating information and commands are exchanged among the modules. When a module receives a critical operating parameter, message for a the module records and learns the identification number of the transmitting module for the purpose State of Health monitoring (Node Alive messages). A critical operating parameter is one which, when not received, requires that the receiving module use a default value for that parameter. Once an identification number is learned by a module, ii will monitor the class 2 serial data circuit for that module's Node Alive message. Each module on the class 2 serial data circuit is required to send a Node Alive message every 2 seconds. If no message is detected from a learned identification number for 5 seconds, a DTC U1xxx (where xxx is equal to the three digit identification number) is set.

CONDITIONS FOR RUNNING THE DTC
^ Diagnostic trouble codes B1327, B1328, U1300, U1301, and U1305 do not have a current status. Any particular device on the class 2 serial data circuit will support some subset of these DTCs.
^ The vehicle power mode (ignition switch position) requires serial data communication to occur.

CONDITIONS FOR SETTING THE DTC
A message from a learned identification number has not been detected for the past five seconds.

CONDITIONS FOR CLEARING THE DTC
^ A current DTC will clear when a Node Alive message from the failed identification number is detected on the class 2 serial data circuit or at the end of the current ignition cycle.
^ A history DTC will clear upon receipt of a scan tool Clear DTCs command.

DIAGNOSTIC AIDS
When multiple Loss of Communication DTCs are set concurrently, the cause is likely to be two opens in the class 2 serial data circuit. Use the Control Module ID Number list in order to determine which modules are not communicating. Use the class 2 serial data circuit schematic in order to determine the location of the opens.

TEST DESCRIPTION
The numbers refer to the step numbers on the diagnostic table.
1. DTCs U1161, U1162, U1163, and U1170 indicate a malfunction in the simple bus serial data circuit.
5. The following modules have a single wire connection to the class 2 serial data circuit. An open in the single wire will prevent communications.
^ Cellular Telephone Docking Station
^ Driver Door Module (DDM)
^ Memory Seat Module (MSM)
^ Navigation Data Processor
^ Steering Column Module
8. The module which was not communicating due to an open in the class 2 serial data circuit may have set Loss of Communication DTCs for those modules that it was monitoring.
10. The modules which can communicate indicate the module which cannot communicate. You must clear the DTC from these modules to avoid future misdiagnosis.