Accelerator Controls Cable Bracket Replacement
REMOVAL PROCEDUREIMPORTANT: Note the cable routing for installation.
1. Remove the cruise control cable retainer (1) at the left strut tower.
2. Remove the cruise control cable (2) from the accelerator controls cable bracket (1).
3. Remove the accelerator cable (3) from the accelerator controls cable bracket (1).
4. Remove the transaxle vent hose (2) clip from the accelerator controls cable bracket (1).
5. Remove the transaxle shift cable clip from the accelerator controls cable bracket.
6. Remove the bolts (2) from the accelerator controls cable bracket (3).
7. Remove the accelerator controls cable bracket (3) from the throttle body (1).
INSTALLATION PROCEDURE
1. Install the accelerator controls cable bracket to the throttle body (1).
NOTE: Refer to Fastener Notice in Service and Precautions.
2. Install the bolts (2) to the accelerator controls cable bracket (3).
Tighten
Tighten the bolts to 12 N.m (106 lb in).
3. Install the transaxle shift cable clip to the accelerator controls cable bracket.
4. Install the transaxle vent hose (2) clip to the accelerator controls cable bracket (1).
5. Install the accelerator cable (3) to the accelerator controls cable bracket (1).
IMPORTANT: Make sure that cables are not rubbing or binding in any manner. The throttle should operate freely without bind between full closed and wide open throttle.
6. Install the cruise control cable (2) to the accelerator controls cable bracket (1).