Seat Cushion Trim Cover and Pad Replacement

Seat Cushion Trim Cover and Pad Replacement

Removal Procedure

1. Remove the seat assembly. Refer to Bucket Seat Replacement (Bucket Seat Replacement) .
2. Remove the seat back. Refer to Seat Back Frame Replacement (Seat Back Frame Replacement) .
3. Disconnect the electrical connectors, if equipped with the heated seats.
4. Remove the J-retainers at the bottom of the seat cushion perimeter.




5. Remove the trim cover from the cushion.
6. In order to expose the bonded area, roll the trim cover away from the foam. Begin at the edge of the trim cover.
7. Fold the glue strip back with the trim cover. Hold the trim cover with one hand.
8. Press down with the other hand on the foam at the edge of the bonded area separating the foam and trim.
9. Gently pull back on the trim as the foam and the trim separate.



Installation Procedure





1. Install the foam cushion on the base.
2. Partially install the trim cover to the cushion.

Important: Do not exceed (1/4 in) diameter of hot glue to the seat cushion foam.


3. Use a 138°C (360°F) hot glue gun. Apply a 6 mm (1/4 in) bead of GM P/N 12377914 or Special Bostik Glue in the first top horizontal channel.
4. Carefully place the trim cover down over the foam so that the trim cover seam is positioned into the glue trench, within thirty seconds of the glue application.
5. Pull the trim cover down. Use a straight edge of the same length as the glued seam. Apply downward pressure (1-4 psi). Hold the trim cover for 1 minute.
6. Pull the trim cover down. Use two straight edges of the same length as the seams. Apply downward pressure (1-4 psi). Hold the trim cover for 1 minute.
7. Lift the trim cover. Apply a 6 mm (1/4 in) bead of glue in the final channel.
8. Pull the trim cover down. Use two straight edges (1) of the same length as the seams. Apply downward pressure (1-4 psi). Hold the trim cover for 1 minute.




9. Connect the electrical connectors, if equipped with a heated seat.
10. Install the J-retainers at the base of the seat cushion.
11. Install the seat back. Refer to Seat Back Frame Replacement (Seat Back Frame Replacement) .

Notice: Refer to Fastener Notice in Cautions and Notices.

12. Connect the electrical connectors.

Tighten the bolts to 24 N.m (18 lb ft).

13. Install the seat assembly. Refer to Bucket Seat Replacement (Bucket Seat Replacement) .