Window Upstop Adjustment

IMPORTANT: The window upstop adjusters (3) are color coded in the following manner:
^ The front upstop adjuster is a neutral color.
^ The rear adjuster is black.

The adjuster has a 6 mm (0.23 in) head. One full turn equals 1 mm (0.04 in) of movement of the glass.

While facing the door inner panel, the following conditions may be observed:
^ A clockwise rotation moves the window up.
^ A counterclockwise rotation moves the window down.

Lower the window slightly in order to relieve pressure before moving the adjusters.

Removal Procedure




1. Remove the roof rail weatherstrip.
2. Insert a 2.6 cm (1 in) wide roll of masking tape (2) in the weatherstrip retainer assembly (3).
3. Place the window in the full up position.
4. Close the door.
5. Measure the gap between the edge of the weatherstrip retainer assembly (3) and the top edge of the window.
Ensure that the gap is 3 mm (0.125 in).

6. If the gap is not within specifications, perform the following steps:
6.1. Determine the necessary amount of movement for the assembly.
6.2. Adjust the upstops, as needed.

Installation Procedure




1. Reinstall the roof rail weatherstrip.
2. Install the water deflector.
3. Install the speaker assembly.
^ Speaker Replacement - Front Lower (with UW6) or Speaker Replacement - Front Lower (with UQ4)
^ Speaker Replacement - Front Lower (with UW6) or Speaker Replacement - Front Lower (with UQ4)
4. Install the door trim panel.