Hazard Warning Switch: Service and Repair

REMOVAL PROCEDURE



1. Disable the SIR. Refer to Disabling the SIR System in SIR.
2. Remove IP upper trim pad.
3. Remove right woodgrain trim panel.
4. Remove electrical connector from hazard switch.
5. Use a flat blade tool to disengage retainers from the switch.




6. Remove switch from air outlet duct.

INSTALLATION PROCEDURE



1. Slide switch into air outlet duct until retainers are fully engaged.
2. Install electrical connector to hazard switch.
3. Install right woodgrain trim panel.
4. Install IP upper trim pad.
5. Enable the SIR system. Refer to Enabling the SIR System in SIR.