Yaw Rate Sensor: Service and Repair

REMOVAL PROCEDURE





1. Turn the ignition switch to the OFF position.
2. Remove the rear compartment trim.
3. Remove the 2 yaw rate sensor mounting nuts.
4. Disconnect the yaw rate sensor electrical connector.
5. Remove the yaw rate sensor from the mounting studs.

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Service Precautions.





1. Install the yaw rate sensor onto the mounting studs.
^ Tighten the 2 yaw rate sensor nuts to 6 Nm (53 inch lbs.).

2. Install the yaw rate sensor electrical connector.
3. Install the rear compartment trim.
4. Perform the ABS Diagnostic System Check.