Installation Procedure

Installation Procedure
1. Install the lap retractor assembly (3) over the stud (2).
2. Align the tab on the retractor with the notch in the seat frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the lap retractor nut.

Tighten
Tighten the nut to 50 N.m (37 lb ft).

4. Install a new rivet in the lap retractor bracket.
5. Install the lap belt retractor cover.
6. Ensure the shoulder belt is not twisted prior to installation.
7. Install the shoulder belt retractor.
8. Install the shoulder retractor nut.

Tighten
Tighten the nut to 50 N.m (37 lb ft).

9. Install the seat belt post rear trim cover.