Exhaust Gas Recirculation (EGR) Valve

REMOVAL PROCEDURE
1. Disconnect the electrical connector from the solenoid.
2. Remove the 2 mounting bolts (2) from the base of the EGR valve (1).
3. Remove the EGR Valve (1).
^ Inspect the EGR passages in the crossover water pump housing for deposits.
^ Clean the EGR passages as needed.
4. Clean the mounting surface for the EGR valve.

INSTALLATION PROCEDURE
1. Install cleaned or replacement EGR valve (1) using a new gasket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the two mounting bolts (2) at base of EGR valve.

Tighten
Tighten the 2 mounting bolts to 24 N.m (18 lb ft).

3. Connect the electrical connector to EGR solenoid.