Installation Procedure

1. Install the heated seat module (1) to the seat cushion frame.





2. Install new rivets (2) to the heated seat module (1) in order to retain the heated seat module to the seat cushion frame.

3. Connect the electrical connector to the heated seat module.





4. Connect the heated seat cushion cover electrical connectors and the wire hold down clips which were removed during disassembly.





5. Remove the protective cover from the seat riser.

6. Install the seat cushion assembly (1) to the seat riser.

Notice:
Refer to Fastener Notice in the Cautions and Notices sub-section of the Service Manual.

7. Install the front fasteners (2) to the seat cushion assembly (1).





8. Adjust the front seat assembly up and forward in order to access the fasteners (1) at the rear of the front seat cushion assembly.

9. Install the front seat cushion assembly rear fasteners (1) to the seat cushion assembly.

Tighten

Tighten the seat cushion assembly rear fasteners to 9 Nm (80 lb in).

10. Angle the front of the front seat cushion up in order to access the front seat cushion assembly fasteners.

Tighten

Tighten the seat cushion assembly front fasteners to 9 N-m (80 lb in).

11. Enable the SIR.

Refer to Enabling the SIR System in the Restraints sub-section of the Service Manual.