Electronic Suspension Control Module Replacement

REMOVAL PROCEDURE
1. Remove the trunk front trim panel.
2. Access the rear electronics compartment.
3. Disconnect the electrical connectors from the CVRSS module.





4. Remove the CVRSS module from the right electronics bay.


INSTALLATION PROCEDURE





1. Install the CVRSS module in the right electronics bay.
2. Connect the electrical connectors to the CVRSS module.
3. Close the rear electronics compartment.
4. Install the trunk front trim panel.
5. Perform the CVRSS module Calibration. Refer to Electronic Suspension Control Module Calibration. Electronic Suspension Control Module Calibration