Front Suspension

REMOVAL PROCEDURE

- Tools Required
- J 21474-5 Bushing Receiver
- J 21474-18 3/8-inch Nut
- J 21474-19 3/8-Inch Bolt
- J 42092 Front Lower Control Arm Horizontal Bushing Remover/Installer kit
- J 42112-4 Rear Differential Remover/Installer Tool
- J 42200 Rear Lower Control Arm Bushing Remover/Installer Bolt





1. Remove the lower control arm.

Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed.

2. Position the J 42092-1 and position the J 42092-2 on either side of the bushing.
3. Press out the horizontal bushing.





4. Position the J 21474-18, J 27474-5, J 42112-4 and position the J 21474-19 around the bushing.
5. Press out the vertical bushing.

INSTALLATION PROCEDURE





1. Position the J 21474-18, J 21474-5, and position the J 21474-19 around the bushing.
2. Press the vertical bushing into the lower control arm until flush.





3. Position the J 42092 -1 and position the J 42092 -2 around the bushing.
4. Press the horizontal bushing into the lower control until flush.
5. Install the lower control arm.