60. Camshaft Cover Installation

1. Lightly coat the new seals, including the O-rings, with engine oil prior to installation to assist in holding the O-ring seals to the camshaft cover.





2. Install the camshaft cover seals.
3. Apply a thin coat of silicone sealer GM P/N 12346240 at the front and at the back of the seals.





4. Install the camshaft cover to the cylinder head.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the camshaft cover bolts.
^ Tighten the camshaft cover bolts to 8 Nm (71 inch lbs.).
6. Install the Cs.
7. On the LH side, connect the ignition Coil Pack Module (CMP) electrical connector and secure the wire with a plastic tie.





8. On the LH side, install the oil filler spout (1) by twisting clockwise and snapping in place.