Rear Position Sensor Replacement

REMOVAL PROCEDURE
1. Raise the vehicle.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect three sensor harness clips from the vehicle.
5. Disconnect the sensor link from the ball stud.
6. Remove the two screws and the position sensor from the vehicle.





INSTALLATION PROCEDURE

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Install the position sensor on the vehicle with two screws.

Tighten two screws to 15 Nm (11 ft. lbs.).

2. Connect the sensor link to the ball stud.
3. Connect the three sensor harness clips onto the vehicle.
4. Connect the sensor harness connector to the vehicle harness connector.
5. Install the wheel onto the vehicle.
6. Lower the vehicle.
7. Perform the ALC Trim Height Adjustment. Refer to TRIM HEIGHT ADJUSTMENT.