Fuel Tank Pressure Sensor: Service and Repair
Fuel Tank Pressure Sensor ReplacementRemoval Procedure
Tools Required
J3473O Fuel Pressure Gauge
Caution: Fuel Vapors can collect while servicing fuel system parts in enclosed areas such as a trunk. To reduce the risk of fire and increased exposure to vapors:
^ Use forced air ventilation such as a fan set outside of the trunk.
^ Plug or cap any fuel system openings in order to reduce fuel vapor formation.
^ Clean up any spilled fuel immediately.
^ Avoid sparks and any source of ignition.
^ Use signs to alert others in the work area that fuel system work is in process.
Notice: Clean all of the following areas before performing any disconnections in order to avoid possible contamination in the system:
^ The fuel pipe connections
^ The hose connections
^ The areas surrounding the connections
1. Relieve the fuel system fuel pressure. Refer to the Fuel Pressure Release Procedure. Fuel Pressure Release
2. Remove the spare tire cover, the jack, and the spare tire.
3. Pull back the trunk liner (1).
4. Remove the bolts from the fuel sender access panel (2).
5. Disconnect the fuel tank pressure sensor (1) electrical sensor connector.
6. Remove the fuel tank pressure sensor clip.
7. Remove the fuel tank pressure sensor (1) from the modular fuel sender.
Installation Procedure
1. Install the new fuel tank pressure sensor (1) on to the modular fuel sender.
2. Connect the fuel tank pressure sensor (1) electrical sensor connector to the fuel tank pressure sensor.
3. Reinstall the fuel tank pressure sensor clip.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the fuel sender access panel bolts.
Tighten the bolts to 2 N.m (18 lb in).
5. Re-position the rear compartment floor trim (1).
6. Reinstall the spare tire cover, the jack, and the spare tire.
7. Tighten the fuel tank filler pipe cap.
8. Connect the negative battery cable.
9. Reinstall the rear seat cushion.
10. Reinstall the intake manifold sight shield. Refer to Engine Cover Replacement Service and Repair.