Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure
1. Raise the vehicle and support.
2. Remove the electrical connector at the cranksensor.




3. Remove the retaining bolt (1) and cranksensor (2 or 3).

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.




1. Install the cranksensor (2 or 3) and the retaining bolt (1)
Tighten the retaining bolt to 10 Nm (89 lb in).
2. Install the electrical connector at the cranksensor.
3. Lower the vehicle.