Turn Signal and Multifunction Switch

DISASSEMBLY

^ Tools Required
- J 41352
- J 42640

1. Remove the upper and lower shroud. Refer to SHROUDS, SHIFT LEVER SEAL.





2. Remove the two wire harness straps (2). Remove one wire harness strap (2) from the steering column tilt head assembly (1).





3. Pop the wire harness assembly (1) from the wire harness strap (2).





4. When working on the power tilt and telescope, column. remove three wire harness Straps (1). Remove one wire harness strap (1).





5. When working on the power tilt and telescope column remove the green (5), brown (4), natural (3) and the black (2) connectors from the E&C interface module assembly (1).





6. When working on the power tilt and telescope column remove the E&C interface module assembly (2) from the lower wire shield (1).





7. When working on the power tilt and telescope column pop open the lower wire shield (1) to remove the wire harness assembly (2).
In the lower wire shield (1), notice which direction (3) and placement the wires are in.





8. Remove the blue (1), black (2), and gray (3) connectors of the turn signal & multifunction switch assembly.





9. Remove the two tapping screws (1).





10. Remove the turn signal & multifunction switch assembly (1).

ASSEMBLY PROCEDURE

Important: The electrical contact must rest on the turn signal cancel cam assembly.





1. Install the turn signal and multifunction switch assembly (1).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.





2. Install the two pan head tapping screws (1).

Tighten the screws to 7 Nm (62 inch lbs.).





3. Route the wire harness assembly along the steering column jacket assembly.





4. Install the blue (1), black (2), and gray (3) connectors of the turn signal and multifunction switch assembly.





5. Pop the wire harness assembly (1) into the wire harness strap (2).





6. Install the two wire harness straps (2). Install one wire harness strap (2) to the-steering column tilt head assembly (1).





7. When working on the power tilt and telescope column install the wire harness assembly (2) into the lower wire shield (1).
In the lower wire shield (1) notice the direction (3) and placement the wires go in.





8. When working on the power tilt and telescope; column slide the Steering Column interface module assembly (2) into the lower wire shield (1).





9. When working on the power tilt and telescope column install the green (5), brown (4), natural (3) and the black (2) connectors into the Steering Column interface module assembly (1).





10. When working on the power tilt and telescope column install the three wire harness straps (2) onto the wire harness assembly.
11. Install the wire harness strap (1) into the steering column tilt head assembly.
12. Install the upper and lower shrouds. Refer to SHROUDS, SHIFT LEVER SEAL.