Cruise Control Switch Assembly - Pivot and Pulse(Bracket)

DISASSEMBLY PROCEDURE
1. Remove the upper and lower shrouds. Refer to SHROUDS, SHIFT LEVER SEAL.
2. Remove the upper tilt head components. Refer to STEERING COLUMN TILT HEAD ASSEMBLY.





3. Remove three pan head tapping screws (2) from the switch mounting bracket (1).





4. Depress the tab (3) on the cruise control switch assembly (2) and remove from the switch mounting bracket (1).
Let the cruise control switch assembly (2) hang freely.





5. Depress the tabs (1) on the pivot & pulse switch assembly (3) and remove from the switch mounting bracket (2) Let the pivot & purse switch assembly (3) hang freely.

ASSEMBLY PROCEDURE





1. Insert the pivot & pulse switch assembly (2) into the switch mounting bracket (1).





2. Insert the cruise control switch assembly (2) into the switch mounting bracket (1).





3. Install the switch mounting bracket (1).

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

4. Install the three head tapping screws (2).

Tighten the screws to 7 Nm (62 inch lbs.).

5. Install the upper tilt head components. Refer to STEERING COLUMN TILT HEAD ASSEMBLY.
Install the upper and lower shrouds. Refer to SHROUDS, SHIP LEVER SEAL.