Left

REMOVAL PROCEDURE

Closeout/Insulator Panel Replacement - IP Lower (Left): Removal Procedure:

1. Remove fasteners (1) at rear edge of insulators to disengage from lower IP.
2. Push in on the snap tab retainers to release.

Closeout/Insulator Panel Replacement - IP Lower (Left): Removal Procedure:

3. Disconnect electrical connectors (1 and 3) as necessary.

Closeout/Insulator Panel Replacement - IP Lower (Left): Removal Procedure:

4. Slide insulator (2) rearward in vehicle to clear emergency brake bracket (1).

INSTALLATION PROCEDURE

Closeout/Insulator Panel Replacement - IP Lower (Left): Installation Procedure:

1. Slide insulator (2) over the top of the emergency brake bracket (1).

Closeout/Insulator Panel Replacement - IP Lower (Left): Installation Procedure:

2. Reconnect electrical connectors (1 and 3).

Closeout/Insulator Panel Replacement - IP Lower (Left): Installation Procedure:

3. Set forward edge onto shelf on carpeting at front of vehicle.
4. Align insulator to floor duct at HVAC module.
5. Align the snap tab fasteners to the IP lower and push upward to engage.
6. Install fasteners (1) into lower IP.

Tighten
Tighten the insulator fasteners to 2 Nm (18 lb in).