U1065

DTC U1065 Loss of Communications with IPM:

CIRCUIT DESCRIPTION
The Class 2 serial data line is used to communicate information between modules. Each module connected to the serial data line is assigned its own recognition code (address). This code is used to identity which modules are communicating. Modules communicate with each other by periodically sending State of Health (SOH) messages. When the ignition switch is in RUN, each module communicating on the serial data line sends a State of Health (SOH) message every 2 seconds to ensure that the system is operating properly. When the Instrument Panel Integration Module (IPM) stops communicating on the Class 2 serial data line, for example if the IPM loses power or ground, the SOH message it normally sends on the serial data line every 2 seconds disappears. This module, which expects to receive that SOH message. detects its absence; this module in turn sets an internal DTC U1065 associated with the loss of SOH of the IPM, which is no longer communicating on the Class 2 serial data line.

CONDITIONS FOR SETTING THE DTC
^ The module does not receive a State of Health (SOH) message from the IPM in 5 seconds.
^ This DTC only sets if RIM DTC B1327, B1328, U1300, U1301 DIM DTC B1982, B1983, U1300, U1301 is not current in module memory.

ACTION TAKEN WHEN THE DTC SETS
^ DTC U1065 is stored in module memory.
^ The module uses the default values for the data it normally receives from the IPM.
^ This DTC does not cause a driver warning message to appear.

CONDITIONS FOR CLEARING THE DTC
^ This DTC clears (status changes from current to history) under any of the following conditions:
- The module detects a State of Health Message from the IPM.
- On each ignition cycle.
^ A history DTC clears after 50 consecutive ignition cycles if the conditions for setting the DTC are no longer present.
^ Use the On-Board clearing DTCs feature. Refer to Clearing DTCs in HVAC Systems with A/C - Automatic.
^ Use a scan tool.

DIAGNOSTIC AIDS
^ DTC module U1065 does not normally represent a failure within the module.
^ When Loss of Class 2 Serial Data Communication DTCs (DTCs with the letter U as the prefix) are stored as history DTCs, know all possible serial data DTCs set in each module before diagnosing the serial data line.
^ If U1065 is stored in module memory, check for the same DTC stored in other modules capable of storing this DTC. The Data Link Connector (DLC) circuit description provides a chart which indicates which modules may set U1065. Refer to Data Link Connector (DLC) in Wiring Systems.
^ If the DTC is a history DTC, the problem may be intermittent.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table:
1. Perform the Body Control Module Diagnostic System Check before continuing with the diagnosis of this DTC.
2. U1065 is the result of loss of communication with the Instrument Panel Integration Module (IPM). Note that other modules on the Class 2 serial data line may also set U1065 if the PM is not communicating on the serial data line. Refer to Data Link Connector in Wiring Systems to identify all modules which may set U1065. Information Bus
4. Clear all DTCs after the repair procedure is complete.