B1656 EEPROM Write Error

DTC B1656 EEPROM Write Error:

Door Control Module Schematics: LFDM Power, Ground Inputs And Outputs:

CIRCUIT DESCRIPTION
The LH Front Door Module (LFDM) performs internal tests on the EEPROM each time that the LFDM performs a write function to a memory address in the EEPROM. The LFDM reads back the data that has been written and compares it to the data. If the data does not match after 3 consecutive write and verify attempts, the LFDM will indicate a write malfunction is current.

CONDITIONS FOR SETTING THE DTC
^ The data read back after a write does not match the data being written 3 consecutive times.
^ The LFDM detects an internal write malfunction.
^ The condition must occur when data is being written.

ACTION TAKEN WHEN THE DTC SETS
^ Stores a DTC B1656 in the LFDM memory.
^ No driver warning message will be displayed for this DTC.
^ The LFDM will store the value being written in another memory address in the EEPROM.

CONDITIONS FOR CLEARING THE DTC
^ This DTC requires a successful write in order to change from current to history.
^ The LFDM no longer detects an internal write malfunction.
^ A history DTC will clear after 50 consecutive ignition cycles if the condition for the malfunction is no longer present.
^ Use the On-Boards clearing DTCs feature.
^ Use a scan tool.

DIAGNOSTIC AIDS
Since the EEPROM cannot be removed from the LFDM and DTC B1656 is an internal LFDM malfunction, the LFDM may be replaced. Refer to Diagnostic Table.

TEST DESCRIPTION
The numbers below refer to the step numbers on the diagnostic table:
1. Perform the Power Door System Diagnostic System Check before continuing with the diagnosis of this DTC.
4. Clear all DTCs after the repair procedure is complete.