Wiper Motor Linkage: Service and Repair
Wiper Transmission ReplacementREMOVAL PROCEDURE
TOOLS REQUIRED
J 39232 Wiper Transmission Separator
1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Remove the transmission drive link from the wiper motor crank arm using the J 39232.
4. Remove six screws.
5. Remove the wiper transmission assembly by guiding it through the access hole in the shroud upper panel.
INSTALLATION PROCEDURE
TOOLS REQUIRED
J39529 Wiper Linkage Installer
1. Position the wiper transmission assembly in the plenum chamber through the shroud upper panel openings.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the six screws.
Tighten
Tighten the screws to 8 N.m (71 lb in).
3. Install the transmission drive link socket to the wiper motor crank arm ball using the J 3952 through.
4. Install the air Inlet grille panel.
5. Install the wiper arms.