Torque Converter Clutch Solenoid: Service and Repair

REMOVAL PROCEDURE
1. Remove the front oil pan.





2. Remove the electrical connectors from solenoid valves (1, 2).
3. Remove the solenoid valve bolts and clip.





4. Remove force motor solenoid valve (3).
5. Remove torque converter clutch solenoid valve (4).

INSTALLATION PROCEDURE
1. Install the torque converter clutch solenoid valve (4).
2. Install the force motor solenoid valve (3).
3. Install the solenoid valve clip and bolts.

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

- Tighten the solenoid valve bolts to 10 Nm (87 inch lbs.).
4. Install the electrical connectors to solenoid valves (1, 2).
5. Install the front oil pan.