4L60-E

PARK/LOCK CONTROL CABLE

REMOVAL

1. Remove negative battery cable and console cover.
2. Place transaxle shift lever in "Park".
3. Turn ignition key to "RUN" position.

Do not attempt to proceed to Step 4 with key in any other position.

4. Left hush panel and loosen drivers side carpet to allow access to cable routing.
5. Column reinforcement plates.
6. Steering column bolts and lower steering column.
7. Slip a screwdriver blade into slot provided ignition switch inhibitor, depress cable latch and pull cable from inhibitor.
8. Pull cable connector lock button at the shifter base to the up position.
9. Snap cable from shifter assembly park lock lever pin.
10. Depress two cable connector latches and remove from shifter base.
11. Remove cable.

Install

Adjust

1. Reinstall cable, ensure correct routing.
2. With cable lock button in the up position and shift lever in the "Park" position, snap cable connector into shifter base.
3. With ignition key in "run" position, snap cable into inhibitor housing.

NOTICE: Do not attempt to insert cable with key in any other position.

4. Turn ignition key to "LOCK".
5. Snap cable end onto shifter park lock lever pin.
6. Push cable outer housing toward shifter to remove slack.
7. With no load applied to connector nose, snap cable connector adjustment lock button down.

Inspect

1. With the shift lever in "PARK" and the key in "LOCK" position, make sure that you cannot move the shifter lever to another position. Ignition key should be removable from column.
2. With the key in "RUN" and the shift lever in "Neutral", make sure that you cannot turn the key to "LOCK".
3. If the above conditions are met, the system is properly adjusted. Proceed to Step 5.
4. If the above conditions are not met, reset cable connector lock to the up position and readjust as indicated in Steps 5 and 6 above, push cable connector lock button down and recheck operation.
5. If key cannot be removed in "PARK" position, snap connector lock button to up position and move cable connector nose away from shifter until key can be removed from ignition.
6. Snap lock button down.
7. Raise steering column, 4 bolts.
8. Steering column reinforcement plate.
9. Reinstall left hush panel, secure carpet.