Rocker Molding With Black Bead Edging

Figure 1 - Rocker Molding:

Remove or Disconnect (Refer to Figure 1)

1. Three screws at front wheel opening molding.
2. Two screws (1) at front end of rocker panel (3).
3. Sill plate.
4. Two screws (1) as in cut-out drawing.
5. One screw through lower hole in tab and rear end cap (2).
6. Ten screws (1).
7. Rocker panel (3).


Install or Connect

1. Position rocker panel (3).
2. Ten screws (1).
3. Position rear end cap (2).
4. One screw through lower hole in tab.
5. Two screws (1) as in cut-out drawing.
6. Sill plate.
7. Two screws (1) at front end of rocker panel (3).
8. Three screw at front wheel opening molding.