B448

In the process of controlling the compressor clutch, the BCM monitors certain system inputs for an indication of low refrigerant charge. If the system refrigerant state of charge should fall below approximately one third its capacity, the BCM is capable of detecting this condition and will display a driver warning message to warn the operator. Refer to Climate Control Diagnostics for details on the control of this message. Heating and Air Conditioning
The BCM determines the state of charge by its low side temperature sensor and the low refrigerant pressure switch. Since temperature and pressure are proportionally related in the A/C system, a low temperature is the same as low pressure. In addition to the message, the BCM will store in memory a diagnostic Code B446, B447 or B448 to indicate that a low refrigerant condition was detected.
1. BCM input value BIO8 displays the voltage state of the circuit at the BCM.
2. Checks to see if the open circuit reading is due to the circuit or the switch.
3. Checks to see if the fault is on the ignition side or the BCM side of the switch circuit.
4. This step checks to see if the fault is due to the pressure switch or a low refrigerant charge.