Engine Front Mount Bracket Replacement

Engine Front Mount Bracket Replacement

Removal Procedure

1. Remove the transmission. Refer to Transmission Replacement (Removal and Replacement).
2. Remove the drive belt. Refer to Drive Belt Replacement (L26) (Service and Repair).

Note: Do not discharge the air conditioning system.

3. Remove the A/C compressor from the engine. Refer to Air Conditioning Compressor Replacement (L26) (Service and Repair)Air Conditioning Compressor Replacement (LS4) (Service and Repair).
4. Secure the compressor away from the bracket area.
5. Remove the engine mount. Refer to Engine Front Mount Replacement (Service and Repair).
6. Remove the engine knock sensor shield and disconnect the sensor harness. Refer to Knock Sensor 2 Replacement (Service and Repair).




7. Remove the front engine mount bracket bolts from the engine.




8. Remove the rear engine mount bracket bolts from the engine.
9. Remove the engine mount bracket from the vehicle.

Installation Procedure

1. Position the engine mount bracket to the engine.
2. Connect the knock sensor harness connector and install the shield. Refer to Knock Sensor 2 Replacement (Service and Repair).




3. Install the rear engine mount bracket bolts to the engine. Hand tighten the bolts at this time.




4. Install the front engine mount bracket bolts to the engine. Hand tighten the bolts at this time.

Caution: Refer to Fastener Caution (Fastener Caution).

5. Install the engine mount bracket bolts.

Tighten the bolts to 102 Nm (75 lb ft).

6. Install the engine mount. Refer to Engine Front Mount Replacement (Service and Repair).
7. Install the A/C compressor to the engine. Refer to Air Conditioning Compressor Replacement (L26) (Service and Repair)Air Conditioning Compressor Replacement (LS4) (Service and Repair).
8. Install the drive belt. Refer to Drive Belt Replacement (L26) (Service and Repair).
9. Install the transmission. Refer to Transmission Replacement (Removal and Replacement).