94. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Special Tools
* J 37096 - Flywheel Holder
* J 45059 - Angle Meter
For equivalent regional tools, refer to Special Tools (Special Tools).




1. Lubricate the seal surface of the crankshaft balancer with engine oil.

Note: The crankshaft position sensor system variation learn procedure must be completed whenever the crankshaft is replaced.

2. Install the crankshaft balancer.
3. Use J 37096 - holder to hold the flywheel.





Caution: Refer to Special Fastener Caution (Special Fastener Caution).

Caution: Refer to Fastener Caution (Fastener Caution).

4. Install the crankshaft balancer bolt and Tighten the crankshaft balancer bolt to 150 Nm (111 lb ft). Use J 45059 - meter to tighten the crankshaft balancer bolt an additional 76 degrees.