Forward Body Mount Replacement

Forward Body Mount Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair) .
2. Remove the exhaust system. Refer to Exhaust System Replacement (RPO L26/3.8L) (Service and Repair)Exhaust System Replacement (RPO LD8) () .
3. Support the forward end of the rear suspension support assembly with a jack stand.
4. Remove the brackets from the body at the support assembly forward mounts.
5. Remove the two bolts securing the front of the support assembly to the body of the vehicle.




6. Lower the front end of the support assembly enough for the forward mount (1) removal.




7. Bend the tabs (1) on the inboard mount (2) and tap the mount downward and out of the support assembly.


Installation Procedure




1. Tap the mount into the support assembly, ensuring that the flat is outboard (2) and the notch (1) is rearward upon installation.
2. Bend the tabs outboard with a large pair of channel lock pliers.
3. Raise the support assembly to the body of the vehicle.

Notice: Refer to Fastener Notice (Fastener Notice) .

4. Install the two bolts securing the front of the support assembly to the vehicle body.

Tighten the bolts to 181 N.m (133 lb ft).

5. Install the brackets to the body at the support assembly forward mounts.

Tighten the bolts to 86 N.m (63 lb ft).

6. Install the exhaust system. Refer to Exhaust System Replacement (RPO L26/3.8L) (Service and Repair)Exhaust System Replacement (RPO LD8) () .
7. Lower the vehicle.