Power Steering Pump Flow Control Valve Replacement - On Vehicle

Power Steering Pump Flow Control Valve Replacement - On Vehicle (L26)

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Install a drain pan under the vehicle.




3. Remove the power steering pressure hose banjo bolt (1).
4. Remove the 2 washers (2), and position the hose (3) aside




5. Remove the flow control valve assembly (3) from the power steering pump.
6. Remove the power steering flow control spring (2).

Installation Procedure




1. Install the power steering flow control spring (2) to the power steering pump.

Notice: Refer to Fastener Notice.

2. Install the power steering flow control valve assembly (3) to the power steering pump.

Tighten the power steering flow control valve assembly (5) to 75 N.m (55 lb ft).




3. Position the power steering pressure hose (3) to the power steering pump, with the 2 NEW washers (2) and install the banjo bolt (1).

Tighten the power steering pressure hose banjo bolt to 55 N.m (41 lb ft).

4. Lower the vehicle.
5. Bleed the power steering system.