94. Crankshaft Balancer Installation

Crankshaft Balancer Installation

Tools Required
^ J37096 Flywheel Holder
^ J45059 Angle Meter





1. Lubricate the seal surface of the crankshaft balancer with engine oil.

2. Install the crankshaft balancer.

Important: The crankshaft position sensor system variation learn procedure must be completed whenever the crankshaft is replaced.

3. Use J37096 to hold the flywheel.





4. Install the crankshaft balancer bolt.
Tighten the crankshaft balancer bolt to 150 Nm (111 ft. lbs.). Use J45059 to tighten the crankshaft balancer bolt an additional 76 degrees.

Notice: Refer to Special Fastener Notice in Service Precautions.

Notice: Refer to Fastener Notice in Service Precautions.