U1500

DTC U1500

CIRCUIT DESCRIPTION
The vehicle communication unit (VCU) and the vehicle interface unit (VIU) communicate using the OnStar(R) Serial Data (-) circuit, OnStar(R) Serial Data (+) circuit and the OnStar(R) Serial Data Return circuit. DTC U1500 is set when the VIU detects no communication between the VIU and the VCU.

DTC DESCRIPTOR
This diagnostic procedure supports the following DTC:
DTC U1500 Inter-device Dedicated Bus Malfunction

CONDITIONS FOR RUNNING THE DTC
- The ignition must be in the RUN or ACC position.
- The system voltage is at least 9.5 volts and no more than 15.5 volts.
- All the above conditions are present for greater than 300 ms.

CONDITIONS FOR SETTING THE DTC
- The VIU detects an open, short to ground or short to B+ on the serial data return circuit.
- The VIU detects an open, short to ground or short to B+ on serial data (-) circuit.
- The VIU detects an open, short to ground or short to B+ on serial data (+) circuit.
- The VIU detects an open on the battery positive voltage circuit.
- All the above conditions are present for greater than 300 ms.

ACTION TAKEN WHEN THE DTC SETS
- The VIU does not communicate with the VCU.
- No calls can be placed.
- The OnStar(R) status LED turns RED.

CONDITIONS FOR CLEARING THE DTC
- The VIU does not detect an open, short to ground or short to B+ on the serial data return circuit.
- The VIU does not detect an open, short to ground or short to B+ on serial data (-) circuit.
- The VIU does not detect an open, short to ground or short or B+ on serial data (+) circuit.
- The VIU does not detect an open on the battery positive voltage circuit.
- A history DTC clears after 50 malfunction-free ignition cycles.
- The VIU receives the clear DTC command from the scan tool.

TEST DESCRIPTION

Steps 1 - 10:

Steps 11 - 14:

The number refers to the step number on the diagnostic table.
2. By disconnecting the VCU you can check the 3 wire bus supply and carrier voltages supplied by the VIU.