Positive: Service and Repair

BATTERY POSITIVE CABLE REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: When replacing battery cables, always use replacement cables that are the same type, gage and length.




1. Disconnect the negative battery cable.
2. Disconnect the positive battery cable from the battery.
3. Remove the ground wire bolt from the frame.




4. Remove the remote positive stud cover.
5. Remove the junction block lead nut from the positive battery cable.
6. Remove the positive battery cable from the bussed electrical center (BEC).
7. Remove the BEC from the strut tower.
8. Unclip and remove the positive battery cable harness from the BEC.
9. Raise and support the vehicle. Refer to Vehicle Lifting.
10. Remove the front lower air deflector.




11. Remove the positive battery cable from the starter motor BAT terminal.
12. Remove the transaxle stud nut.
13. Remove the ground cable from the transaxle stud.




14. Unclip and remove the battery cable harness from the retainers.
15. Remove the battery cable harness from the vehicle.
16. Remove the positive battery cable from the wiring harness conduit.

INSTALLATION PROCEDURE




1. Install the positive battery cable into the wiring harness conduit.
2. Install the battery cable harness to the vehicle.
3. Install the battery cable harness to the retainers.
4. Install the ground cable to the transaxle stud.
5. Install the transaxle stud nut.

Tighten the nut to 30 N.m (22 lb ft).

NOTE: Refer to Fastener Notice in Service Precautions.




6. Install the positive battery cable to the starter motor BAT terminal.
7. Install the nut to the starter solenoid BAT terminal.

Tighten the nut to 9.5 N.m (84 lb in).

8. Install the front lower air deflector.
9. Lower the vehicle.
10. Install the positive battery cable harness to the BEC.
11. Install the BEC to the strut tower.




12. Install the positive battery cable to the BEC.
13. Install the junction block lead nut to the positive battery cable.

Tighten the lead nut to 10 N.m (89 lb in).

14. Install the remote positive stud cover.
15. Install the ground wire and the bolt to the frame.

Tighten the bolt to 10 N.m (89 lb in).




16. Install the positive battery cable to the battery.

Tighten the terminal bolt to 15 N.m (11 lb ft).

17. Connect the negative battery cable.