Ignition Coil(S) Replacement - Bank 2

IGNITION COIL(S) REPLACEMENT - BANK 2

REMOVAL PROCEDURE
1. Turn the ignition OFF.




2. Disconnect the applicable ignition coil electrical connector(s).




3. Remove the ignition coil bolt(s).
4. Remove the ignition coil(s).

INSTALLATION PROCEDURE




1. Install the ignition coil(s).
2. Install the ignition coil bolt(s).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the ignition coil bolt(s) to 10 N.m (89 lb in).




3. Connect the ignition coil electrical connector(s).