EGR Valve: Service and Repair
EXHAUST GAS RECIRCULATION (EGR) VALVE REPLACEMENTREMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Disconnect the electrical connector from the exhaust gas recirculation (EGR) valve.
3. Remove the two EGR valve retaining nuts (4).
4. Remove the EGR valve (1).
5. Remove the gasket (2) from the EGR valve inlet pipe.
6. Clean the EGR valve inlet pipe (3) of dirt and debris.
INSTALLATION PROCEDURE
1. Install a new gasket (2) on the EGR inlet pipe.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the EGR valve (1) and two nuts (4).
Tighten
Tighten the nuts to 30 N.m (22 lb ft).
3. Connect the EGR valve electrical connector.