Extension Housing: Service and Repair

Case Extension Housing Replacement
Removal Procedure
1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove the right drive axle from the transaxle.
4. Remove the Transaxle brace.
5. Remove the vehicle speed sensor.





6. Remove the case extension housing bolts (5).
7. Remove the case extension housing (6) with the axle seal and the O-ring (8).

Installation Procedure





1. Install the O-ring (8) to the case extension housing (6).
2. Install the case extension housing (6) with the axle seal and the O-ring (8).

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the case extension housing bolts (5).
Tighten the bolts to 36 Nm (27 ft. lbs.).
4. Install the vehicle speed sensor.
5. Install the transaxle brace.
6. Install the right drive axle to the transaxle.
7. Lower the vehicle.
8. Connect the negative battery cable.

Notice: Refer to Do Not Overfill the Transmission Notice in Cautions and Notices.

9. Check and fill the transaxle as necessary.
10. Inspect for fluid leaks.