Driver/Vehicle Information Display: Service and Repair
DRIVER INFORMATION CENTER SWITCH REPLACEMENTREMOVAL PROCEDURE
1. Remove the IP cluster trim plate (1).
2. Disconnect the electrical connector.
3. Remove the fasteners (2) from the driver information switch.
4. Remove the driver information center switch (3).
INSTALLATION PROCEDURE
1. Install the driver information center switch (3) to the IP cluster trim plate (1).
2. Install the fasteners (2).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the fasteners to 2 N.m (18 lb in).
3. Connect the electrical connector.
4. Install the IP cluster trim plate (1).