Instrument Panel Cluster (IPC) - Trim Plate Bezel Replacement

Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster

Removal Procedure




1. Remove the left I/P trim plate.
2. Remove the right I/P trim plate.
3. Raise the tilt steering column to the highest position.
4. Remove the 2 fasteners (1).
5. Lower the tilt steering column to the lowest position.
6. Disengage the 4 clips across the top edge, and the 4 clips across the bottom edge that retain the I/P cluster trim plate to the I/P by gently pulling toward the rear of the vehicle.
7. Set the parking brake.
8. Move the gear selector lever to the L1 position.
9. Tilt the top of the bezel rearward in order to remove.
10. Disconnect the electrical connector (3) from the driver information center switch (5).

Installation Procedure




1. Connect the electrical connector (3) to the driver information center switch (5).
2. Press the I/P cluster trim plate into the I/P. Ensure that the clips line up with the holes in the I/P.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the fasteners (2).

Tighten the 2 fasteners (1) to 2 N.m (18 lb in).

4. Install the right I/P trim plate.
5. Install the left I/P trim plate.