94. Crankshaft Balancer Installation

Crankshaft Balancer Installation

^ Tools Required
- J 29113 Crankshaft Balancer Installer
- J 36660-A Torque Angle Meter





1. Apply sealer G M P/N 12346286 (Canadian P/N 10953472) or the equivalent to the keyway of the crankshaft balancer.
2. Place the crankshaft balancer into position over the key in the crankshaft.
3. Install the J 29113 onto the crankshaft.
4. Pull the crankshaft balancer into position.
5. Remove the J 29113 from the crankshaft balancer.





Notice: Refer to Fastener Notice in Service Precautions.

Notice: Do NOT use a power-assisted tool with the special tool in order to remove or install this component. You cannot properly control the alignment of this component using a power-assisted tool, and this can damage the component.

6. Install the crankshaft balancer washer and bolt.
^ Tighten the crankshaft balancer bolt a first pass to 70 Nm (52 ft. lbs.).
^ Tighten the crankshaft balancer bolt a final pass to 85° using the J 36660-A.