Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring

Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement On Vehicle

- Tools Required
- J 23653-SIR Steering Column Lock Plate

Removal Procedure

Caution: Refer to SIR Caution in Service Precautions.





1. Disable the SIR system.
2. Remove the inflatable restraint steering wheel module coil.
3. Install J23653-SIR to the upper steering shaft.
4. Using J23653-SIR depress the lock plate and remove the retaining clip.
5. Remove J23653-SIR from the upper steering shaft.
6. Remove the shaft lock shield assembly (1).
7. Remove the turn signal cancel cam assembly (2).
8. Remove the upper bearing spring (3).

Installation Procedure





1. Install the upper bearing spring (3).
2. Install the turn signal cancel cam assembly (2).
3. Install the shaft lock shield assembly (1).
4. Install a new bearing retainer.
5. Install J 23653-SIR to the steering column.
6. Using J 23653-SIR depress the lock plate.
7. Push the bearing retainer into place.
8. Remove the J23653-SIR from the steering column.
9. Install the inflatable restraint steering wheel module coil.
10. Enable the SIR system.