Forward Servo

Forward Servo Replacement
Removal Procedure
1. Install the engine support fixture. Refer to Engine Support Fixture or Engine Support Fixture.
2. Raise and support the vehicle.
3. Remove and support the power steering gear. Refer to Power Steering Gear Replacement.
4. Remove the transaxle mount lower nuts. Refer to Automatic Transmission Mount Replacement.
5. Remove the engine mount lower nuts. Refer to Engine Mount Bracket Replacement or Engine Mount and Bracket Replacement.
6. Remove the power steering lines from the right side of the frame.
7. Support the rear of the frame with a jackstand.
8. Loosen the front frame bolts and remove the rear frame bolts.
9. Adjust the jackstand to lower the rear of the frame.
10. Position a drain pan under the forward servo cover.





11. Remove the servo cover bolts.
12. Remove the forward servo cover.
13. Remove the forward servo cover O-ring.
14. Remove the servo piston assembly.
15. Remove the servo spring.

Installation Procedure





1. Install the spring.
2. Install the piston assembly.
3. Install the O-ring.
4. Install the servo cover.
5. Install the servo cover bolts.
^ Tighten the bolts to 11 Nm (97 inch lbs.).
6. Remove the drain pan from under the forward servo cover.
7. Adjust the jackstand in order to raise the rear of the frame.
8. Install the frame bolts.
9. Remove the support from the rear of the frame.
10. Install the power steering lines to the right side of the frame.
11. Install the engine mount lower nuts. Refer to Engine Mount Bracket Replacement or Engine Mount and Bracket Replacement.
12. Install the transaxle mount lower nuts. Refer to Automatic Transmission Mount Replacement.
13. Install the power steering gear. Refer to Power Steering Gear Replacement.
14. Lower the vehicle.
15. Remove the engine support fixture.
16. Check and fill the transmission as necessary.