Water Pump: Service and Repair

Water Pump Replacement

Removal Procedure
1. Drain the cooling system.
2. Remove the drive belt guard.





3. Loosen the water pump pulley bolts.
4. Remove the drive belt.





5. Remove the water pump pulley bolts.
6. Remove the water pump pulley.
7. Remove the water pump bolts.
8. Remove the water pump.
9. Remove the water pump gasket.
10. Clean the water pump mating surfaces.

Installation Procedure





1. Install the gasket.
2. Install the water pump.

Notice: Refer to Fastener Notice in Service Precaution.

3. Install the water pump bolts.
Tighten the bolts to 10 Nm (89 inch lbs.).
4. Install the water pump pulley.





5. Install the water pump pulley bolts.
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Install the drive belt.
7. Install the drive belt guard.
8. Fill the cooling system.
9. Inspect for leaks.