Ashtray Replacement - IP

REMOVAL PROCEDURE




1. Remove the instrument panel accessory trim plate.
2. Remove the screws (1) from the instrument panel ashtray bracket.
3. Remove the IP ashtray (2) from the instrument panel accessory trim plate.
4. Disconnect the electrical connector from the ashtray.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the ashtray.
2. Position the instrument panel ashtray (2) to the Instrument panel accessory trim plate.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the screws (1) to the instrument panel ashtray bracket.

Tighten
Tighten the instrument panel ashtray bracket screws to 2 N.m (18 lb in).

4. Install the instrument panel accessory trim plate.