Accumulator: Service and Repair
Accumulator and 2-1 Manual Servo ReplacementRemoval Procedure
1. Raise and support the vehicle.
2. Remove the oil pan.
3. Remove the filter.
4. Remove the accumulator attaching bolts (131).
5. Remove the manual 2-1 band servo cover bolts (103).
6. Remove the accumulator (132).
7. Remove the manual 2-1 band servo cover (104).
8. Remove the manual 2-1 band servo (106-116).
9. To disassemble, inspect and service the accumulator and 2-1 manual servo, refer to Service and Repair.
Installation Procedure
1. Install the manual 2-1 band servo (106-116).
2. Install the manual 2-1 band servo cover (104).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the manual 2-1 band servo cover bolts (103).
^ Tighten the manual 2-1 band servo cover bolts (103) to 24 Nm (17 ft. lbs.).
4. Install the accumulator (132).
5. Install the accumulator attaching bolts (131).
^ Tighten the accumulator attaching bolts (131) to 11 Nm (97 inch lbs.).
6. If removed, install the new filter seal.
7. Install the filter.
8. Install the oil pan.
9. Lower the vehicle.