Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION (CMP) SENSOR REPLACEMENT

REMOVAL PROCEDURE

Locations View:

1. Turn OFF the ignition.
2. Remove the power steering pump.
3. Disconnect the CMP sensor electrical connector.
4. Remove the attaching bolt.
5. Remove the CMP sensor.
6. Inspect the sensor O-ring for wear, cracks or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE

Locations View:

1. Lubricate the O-ring with clean engine oil. Replace the O-ring if the O-ring is damaged.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the CMP sensor.

Tighten
Tighten the retaining bolt to 8 N.m (71 lb ft).

3. Connect the CMP sensor electrical connector.
4. Install the power steering pump.