Air Cleaner Housing: Service and Repair
AIR CLEANER ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Remove the 3 bolts from the inner fender brace and remove the brace.
3. Remove the air intake duct.
4. Remove the 2 screws (2) from the 2 air cleaner housing sections (1-3).
5. Remove the air cleaner housing cover assembly (1).
6. Without disconnecting the PCM connectors, remove the PCM and harness from the PCM housing.
7. Carefully remove the PCM housing (1) by pulling the cover from the 2 rubber grommets (2) in the engine compartment. Inspect the assembly for signs of damage and replace if required.
INSTALLATION PROCEDURE
1. Carefully install the PCM housing (1) by pushing the cover into the 2 rubber grommets (2) in the engine compartment.
2. Carefully install the PCM and harness into the PCM housing (3).
3. Install the air cleaner housing cover assembly (1).
4. Install the 2 screws (2) from the 2 air cleaner housing sections.
5. Install the air intake duct.
6. Position the inner tender brace and install the 3 bolts.